Changeset 112 for ctrl/firmware/Main/CubeMX/charger.ioc

Timestamp:

Mar 21, 2025, 3:58:22 PM (7 weeks ago)

Author:

Zed

Message:

Fixing project. Need to add CAN in CubeMX.

File:

• ctrl/firmware/Main/CubeMX/charger.ioc (modified) (5 diffs)

ctrl/firmware/Main/CubeMX/charger.ioc

@@ -26 +26 @@
 ADC2.Ratio=256
 ADC2.RightBitShift=ADC_RIGHTBITSHIFT_8
-ADC2.SamplingTime-0\#ChannelRegularConversion=ADC_SAMPLETIME_64CYCLES_5
-ADC2.SamplingTime-2\#ChannelRegularConversion=ADC_SAMPLETIME_64CYCLES_5
-ADC2.SamplingTime-3\#ChannelRegularConversion=ADC_SAMPLETIME_64CYCLES_5
+ADC2.SamplingTime-0\#ChannelRegularConversion=ADC_SAMPLETIME_32CYCLES_5
+ADC2.SamplingTime-2\#ChannelRegularConversion=ADC_SAMPLETIME_32CYCLES_5
+ADC2.SamplingTime-3\#ChannelRegularConversion=ADC_SAMPLETIME_32CYCLES_5
 ADC2.SingleDiff-0\#ChannelRegularConversion=ADC_DIFFERENTIAL_ENDED
 ADC2.SingleDiff-2\#ChannelRegularConversion=ADC_DIFFERENTIAL_ENDED
@@ -509 +509 @@
 PA8.Locked=true
 PA8.Signal=GPIO_Input
+PB0.GPIOParameters=GPIO_Label
+PB0.GPIO_Label=BAT_U_SENSE_MINUS
 PB0.Locked=true
 PB0.Signal=ADCx_INN5
+PB1.GPIOParameters=GPIO_Label
+PB1.GPIO_Label=BAT_U_SENSE_PLUS
 PB1.Signal=ADCx_INP5
 PB10.GPIOParameters=GPIO_Speed,GPIO_Label
@@ -529 +533 @@
 PB15.Mode=Full_Duplex_Master
 PB15.Signal=SPI2_MOSI
-PB2.GPIOParameters=GPIO_Label
+PB2.GPIOParameters=PinState,GPIO_Label
 PB2.GPIO_Label=U_BAT_SCALE_SWITCH
 PB2.Locked=true
+PB2.PinState=GPIO_PIN_RESET
 PB2.Signal=GPIO_Output
 PB4(NJTRST).GPIOParameters=PinState,GPIO_Label
@@ -558 +563 @@
 PB9.Signal=GPIO_Output
 PC0.GPIOParameters=GPIO_Label
-PC0.GPIO_Label=U_BAT
+PC0.GPIO_Label=BAT_U_RAW
 PC0.Locked=true
 PC0.Signal=ADCx_INP10
@@ -571 +576 @@
 PC15-OSC32_OUT.Mode=LSE-External-Oscillator
 PC15-OSC32_OUT.Signal=RCC_OSC32_OUT
+PC4.GPIOParameters=GPIO_Label
+PC4.GPIO_Label=LOAD_I_SENSE_PLUS
 PC4.Signal=ADCx_INP4
+PC5.GPIOParameters=GPIO_Label
+PC5.GPIO_Label=LOAD_I_SENSE_MINUS
 PC5.Signal=ADCx_INN4
 PC6.GPIOParameters=GPIO_PuPd,GPIO_Label