source: ctrl/firmware/Main/CubeMX/charger.ioc

Revision Log Mode:


Legend:

Added
Modified
Copied or renamed
Diff Rev Age Author Log Message
(edit) @89   3 months Zed Added basic I2C EEPROM support.
(edit) @88   3 months Zed BME280 data transfer works ok. Device returns its ID 0x60.
(edit) @87   3 months Zed RTC is working.
(edit) @85   3 months Zed Fixing project before adding 1Wire port in CubeMX.
(edit) @84   3 months Zed Added TIM6 in CubeMX to generate 1µs delays for 1-Wire Protocol.
(edit) @83   3 months Zed Modbus Master and Slave Hardware were tested.
(edit) @82   3 months Zed DMA transfer to µSD-card was implemented.
(edit) @81   3 months Zed Modbus Master and Slave interfaces were added.
(edit) @79   3 months Zed DHCP client can get IP-address from fritz!box
(edit) @77   3 months Zed LwIP was removed from the project.
(edit) @76   3 months Zed Fixing project before changing NSS control for SPI2 in CubeMX.
(edit) @75   3 months Zed FatFs? is working, but without DMA.
(edit) @74   3 months Zed FatFs? with DMA were implemented.
(edit) @73   3 months Zed FreeRTOS can be compiled without errors.
(edit) @72   3 months Zed FreeRTOS was added to the project.
(edit) @70   3 months Zed AZRTOS and NetX were removed from the project.
(edit) @69   4 months Zed NetX can be compiled and initialized.
(edit) @66   4 months Zed FAN PWM control and TACHO signal measuring are working.
(edit) @65   4 months Zed GSM, USB, BLE and GPS are working.
(edit) @64   4 months Zed USART3 TX DMA is working.
(edit) @63   4 months Zed Fixing project.
(edit) @62   4 months Zed GSM STATUS pin is working.
(edit) @61   4 months Zed GSM thread was added.
(edit) @59   4 months Zed HAL library was updated. SD DETECT pin is working.
(edit) @58   5 months Zed POWER_ENABLE lines for 4V, 5V, 10V and 15V were tested.
(edit) @57   5 months Zed FileX is working.
(edit) @56   5 months Zed Tick rate was changed to 1000 in CubeMX.
(edit) @54   5 months Zed SDMMC(DMA) and Azure_RTOS(with FileX) are activated.
(edit) @51   5 months Zed SDMMC low level driver was added.
(edit) @50   5 months Zed LED control description were added.
(edit) @48   5 months Zed Backlight was turned on for Display.
(edit) @47   5 months Zed
(edit) @45   5 months Zed Added SPI module for Display.
(edit) @39   5 months Zed RTC module was activated.
(edit) @38   5 months Zed Instruction and Data caches were activated.
(edit) @10   6 months Zed Added SEGGER project files.
(add) @9   6 months Zed
Note: See TracRevisionLog for help on using the revision log.